Enter your current weld parameters and tick the symptoms you're seeing — flash issues, HAZ problems, oxide lines, spindle stalls, dimensional drift — and get specific parameter changes to try, primary and secondary, with root-cause notes. If you have a parameter set from the Parameter Generator, you can load it directly.
← Back to Friction WeldingThe suggested changes are starting points to consider, not instructions to follow. Before applying any change you must clearly understand the weld cycle graph, the component geometry, the tooling and alignment, and the mechanical and electrical capabilities of your machine. Expert review of all of these is essential.
The level of change required varies for every situation, and this tool is set deliberately conservatively. These are suggestions to consider — you must make your own decision on whether to try them. Any damage, loss, or injury resulting from applying these changes is not the responsibility of Griffiths Engineering Solutions Ltd in any way.